New tires will be necessary in order to fix the acquired vibration problem. If the band saw is not going to be used for a long period, that over-tension of the blade on the saw can cause flat spots on the tires. Over-tension might cause the saw’s bearings to fail. A blade can take a little more tension than the gauges recommend, but it is not always a good idea. Many experienced operators recommend a slight over-tension of the blade in order to achieve a better cut. By wobbly: like the sound you hear just by shaking the blade. The blade will produce a tone that should sound clear rather than wobbly. To manually check the tension, tighten the blade, flick it with a finger, or pluck it. Depending exclusively on the gauges may not give as accurate a read. When installing a band saw blade, one of the very first things to do is measure the tension of the blade while it is on the band wheels. This is necessary and should be done with every new blade. There are four primary steps to help you optimize the band saw blade’s capability. In order for these results to be achieved, the band saw in use must be tuned correctly or the re-sawing will become difficult. The band saw is essential for cutting such curves and for re-sawing veneers. Few things are more satisfying than re-sawing thin sheets of veneer out of a large piece of wood. The band saw machine is an important tool for woodworkers. Tuning the band saw is a necessary evil if perfection of cut, smoothness of materials, and pride in workmanship are the desired end-result of any work effort.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |